General safety and operating information applicable to electrical equipment installed within
hazardous locations. This information must be understood by all persons installing, using, or
maintaining the electrical equipment. This information is designed to aid personnel in safe
installation, operation, and maintenance of the "D" Series equipment. It is not designed to replace or
limit appropriate safety measures applicable to work performed by personnel. Any additional safety
and operating measures that are required must be determined by and followed by personnel
performing work on the electrical equipment.
WARNING:
Deviation from the specified instructions or procedure steps can result
in injury to personnel, equipment malfunction or equipment damage.
WARNING:
Return unit to factory for any repairs or replacement of parts, customer
not permitted to repair. This will void all warranties and hazardous area
certification(s) if non-authorized repair occurs.
General Precautions:
Slip resistant gloves and protective eyewear (glasses with side shields or goggles as appropriate)
should be worn when installing and servicing any part of electrical equipment. Hot components
should be allowed to cool before servicing if possible. Other appropriate equipment or clothing must
be used as required by the type of work performed. All applicable regulations and procedures must
be followed for the work performed. Before beginning any work on the equipment, carefully consider
all the potential hazards and ensure that appropriate measures are taken to prevent injury to
personnel or equipment damage.
CAUTION:
Electrical equipment components may be hot even when power is
not applied. Take appropriate precautions to prevent injury from contact with hot
items.
12
WARNING:
NEVER open the main housing of the "D" Series unless
authorized and trained and certified to do so
The main housing is manufactured in a controlled environment that eliminates
moister at the factory and is only to be opened by factory certified technicians at an
authorized repair facility. Opening of the main housing will void all warranties.
CAUTION:
Failure to allow adequate cooling of electrical equipment components
with hot surfaces before opening the enclosure can lead to injury of personnel or
equipment damage.
General Safety and Operating Information:
105607312018 D201-x-Q6055-E
INSTALLATION MANUAL REV-1
