4
SPEKTRUM DX5C • TRANSMITTER INSTRUCTION MANUAL
EN
NOTICE:
Digital servos are required with the SRS6000 AVC receiver. Using analog servos with AVC technology will reduce the
performance of the system and may cause the servos to overheat.
AUX CHANNELS AND AVC TECHNOLOGY
When AVC is active, the radio system will use the AUX 1 and
AUX 2 channels for gain control. The AUX 1 and AUX 2 ports
can be used in AVC mode to power a personal transponder,
lights, drive servos, or operate auxillary devices. AUX 1 will
follow steering gain, and AUX 2 will follow throttle gain.
AUX 1 and AUX 2 are not available for use in mixes when AVC
is active. For an independent channel, use AUX 3.
NOTICE:
Do not cut, kink, or modify the antenna.
Damage to the coaxial portion of the antenna will
reduce the performance of the antenna. Shortening or
cutting off the 31mm tip may reduce the range to a
small fraction of what it should be.
ANTENNA INSTALLATION
The SR415 and SRS6000 receivers have a coaxial style antenna.
Position the antenna vertically and away from the vehicle in an
antenna tube. Make sure the tip of the antenna is as high as
posible to maximize the signal strength.
SR415 RECEVIER INSTALLATION (NO AVC)
Use double sided servo tape, hook and loop tape or foam rubber
to mount the SR415 reciever securely where it is protected and
isolated from vibration.
TYPICAL ELECTRIC VEHICLE INSTALLATION
TYPICAL NITRO VEHICLE INSTALLATION
Receiver
Motor
Electronic
Speed Control
Steering Servo
Battery
Receiver
Steering Servo
Throttle Servo
Battery
RECEIVER INSTALLATION
SRS6000 AVC RECEIVER INSTALLATION
Install the SRS6000 receiver in the vehicle before binding the
transmitter and receiver. The receiver can be mounted completely
fl at (label side up) or completely perpendicular on its side. When
binding the receiver, the AVC system automatically detects the
orientation of the receiver.
If the receiver is angled, AVC technology may not function
properly. If the orientation of the receiver is modifi ed after binding,
you must rebind for AVC technology to function properly.
IMPORTANT:
Do not use hook and loop tape to install the
SRS6000 receiver. Using hook and loop tape will affect the
performance of the AVC system.
AUX 1 Port
AUX 2 Port
AUX 3 Port
AUX 4/Disable Port
Antenna
Bind/Battery Port
Steering Port
Throttle Port
OR
