23
SPEKTRUM DX8 • RADIO INSTRUCTION MANUAL
To Access the Reverse Function
With the transmitter on and the main or telemetry screen up, press the roller.
Note:
Your aircraft manual may refer to this as changing transmitter flight
control directions in the Control Test/Reverse Controls section.
Highlight Travel then rotate the roller to access the Reversing screen.
Highlight the channel desired and press the roller to select.
Highlight the REV NOR function then press the roller to access. Press the roller to
toggle between NOR and REV.
To Access the Speed Function
With the transmitter on and the main or telemetry screen displayed, press the
roller. The Function list displays.
Rotate the roller to highlight Servo Setup then
press to access the Servo Setup screens. Servo travel will be highlighted. Rotate
the roller until Speed appears in the channel position then press to enter.
Highlight the channel then press the roller. Rotate the roller to access the channel
you wish to adjust. Press the roller to accept.
Highlight the Speed value at the bottom of the screen and press the roller to
access. With the Speed value highlighted rotate the roller to adjust the servo
speed for the selected channel. Press the roller to accept the value.
D/R & EXPONENTIAL
Dual Rates and exponentials are available on the aileron, elevator and rudder
channels. You can assign them to numerous switches including the flight mode
switch.
Dual Rate
Affects the overall travel which in turn affects control response
sensitivity equally throughout the range of that channel. Reducing
the dual rate reduces the maximum control rate as well as overall
sensitivity.
Exponential
Affects the sensitivity around center but has no affect on the overall
travel. Positive Exponential reduces control sensitivity around neutral
for more precise control but does not affect the maximum control response.
Note:
Positive and negative exponential values are available. A positive
expo value reduces control sensitivity around center. It does not affect
maximum travel and is recommended. Negative exponential values
increase sensitivity around neutral and is seldom used.
To Access the D/R and Expo Function
With the transmitter on and the main or telemetry screen displayed, press the
roller. The Function list will display.
Rotate the roller to highlight D/R and Expo then press to access.
To Select a Channel
Highlight the channel then press the roller to access. Rotate the roller to select the
aileron, elevator or rudder channel. Press to accept.
You can return to the
Function List
screen at anytime by
pressing the
back
button on the transmitter
once
.
To return to the
Main
screen press the
back
button on the
transmitter
twice
or press and hold the
Roller
for more than
three seconds.
EN
Summary of Contents for DX8
Page 2: ......
Page 84: ...42 SPEKTRUM DX8 Bedienungsanleitung De ...
Page 207: ...41 SPEKTRUM DX8 RADIO MANUAL DE INSTRUCCIONES NOTES ES ...
