F1XX Series Casing Material Specifications
ALUMINUM
15lbs
NOTE: Spectrum Camera Solutions, LLC is NOT responsible for any
misuse or improper installation of product, assumes no liability for special
or consequential damages caused by use or misuse or improper
installation of its products sold and assumes no liability for injury from use
or misuse or improper installation of its products or attachedproducts.
SPECIFICATIONS
Power Source Specification
For F101-P1377-BD & F101-P1375-BD & F101-P1378-BD
The power supply used with this product shall have a rated output voltage within voltage
range of 12-24 VAC/VDC. The power supply shall also fulfill one of the following
requirements: • Safety Extra Low Voltage (SELV) according to clause 2.2 of IEC/EN/UL
60950-1 and Limited Power Source (LPS) according to clause 2.5 of IEC/EN/UL 60950-1
or CEC/NEC Class 2 source of supply as defined in the Canadian Electrical Code, CSA
C22.1 and National Electrical Code, ANSI/NFPA 70 • Class 1 electrical energy source
(ES1) and Class 2 power source (PS2) rated output power
limited to ≤100 W according to
IEC/EN/UL 62368-1. When used with Power over Ethernet (PoE) the Power sourcing
equipment (PSE) shall comply with IEEE 802.3af/802.3at and Limited Power Source (LPS)
according to clause 2.5 of IEC/EN/UL 60950-1 or annex Q of IEC/EN/UL 62368-1.
Grounding Specification
For F1XX
For U.S zones, the internal grounding connection must be used, and the external
grounding connection shall be a supplemental grounding connection. The product shall be
grounded either through a shielded network cable (STP) or other appropriate method.
F101-P137(5,7,8)-BD REV 2 114309212018 F1XX
SERIES INSTALLATION REV-2A
13
