2.3 Installation Guideline
The device is in the storage state when it leaves the factory. Please follow the steps
below to prepare for installation.
1. Take the device and its accessories out of the box or plastic bag;
2. Tear off the protective film on the screen and lens of the device if there is any;
3. Remove the wire tie that binds the wire.
2�3�1 Installation Position
● Do not install the device in a position blocking the view of the driver or in an unsafe
area.
● Install the device near the rearview mirror but not in a place blocking the driver vision.
● Install the device within the wiper blade area to ensure clear capture on rainy days.
● Do not install the device on the airbag cover or near the airbag operating range.
● Do not install the device on the windscreen protection film to prevent damage to the
film.
● Install the device in a position not affecting any other electronic devices in your vehicle.
Note: Please follow the instruction or warnings above strictly� Our
company assumes no responsibility for any injury or death caused by
car impact or airbag problems�
05