2.3 Installation Guideline
The device is in the storage state when it leaves the factory. Please follow the steps below
to prepare for installation:
1. Take the device and its accessories out of the box or plastic bag;
.
2. Tear off the protective film on the screen and lens of the device;
.
3. Remove the wire tie that binds the wire.
TF Card Installation
Insert the TF card into the slot with the pins facing upwards. Push the TF card forward, and
the card can be removed after it pops out. Please use the 32GB TF card that comes with
the product. A third-party TF card should meet these requirements:
Class 8 or above,
maximal 128GB
.
Note: Installing and removing the TF card in the recording mode may result in failure of recording
videos and causing damage to the TF card. Please turn off the device before inserting or
removing the TF card.
Magnetic Suction Bracket Installation
1. Aim the magnetic transfer slide buckle at the mount buckle on the device.
.
2. Hold the device and chuck bracket with your hands, and aim the mount at the chuck
bracket on the device.
.
3. Select a proper position (such as the center of the rearview mirror), attach the suction
mound to the windshield and rotate the mount clockwise to lock.
.
4. Adjust the recording angle (it is the best angle that the car front shows in the middle of
the display).
Note: The first and second steps have been completed when the product leaves the factory. You
only need to perform the third and fourth steps. You can pull down the device directly from the
suction bracket now and reinstall the device back to its position by bringing the device near to the
magnetic slider.
5
TF Card Installation
Magnetic Suction Bracket Installation
