GETTING STARTED
9
GETTING STARTED
INSERTING MEMORY CARD
Before installing or replacing the
memory card, switch off the recorder.
If you remove the memory card
while recording, you may lose all the data.
If you want to save the recorded data onto the external
memory, you should insert a memory card.
The memory card slot is located at the left side panel
of the voice recorder, marked with the label and
covered with protective shield marked
SD
.
To install a memory card:
– Open the protective shield;
– Carefully insert the memory card into the slot to-
wards the device front panel;
– Slightly press the edge of the card to fix it in the slot;
– Close the protective shield.
To extract a memory card from the voice recorder:
– Open the protective shield;
– Press the edge of the card and carefully extract it
from the slot;
– Close the protective cover.
INSERTING BATTERIES
The slot for batteries is located at the back panel of the voice re-
corder and is covered with a protective cover.
To install the batteries:
– Open the protective cover;
– Switch the key
Charge
/
Bat
into
Charge
position if using accu-
mulator batteries;
– Switch the key
Charge
/
Bat
into
Bat
position if using non-
rechargeable batteries;
– Insert two batteries, observing the correct polarity;
– Close the protective cover.
To avoid the voice recorder’s breakdown it is strictly
forbidden to use non-rechargeable batteries with
Charge
key
position.
