Page 9
STEP 5:
Connect the end of the 1/2” ID x 38” hydraulic pressure hose (1) coming from the fitting on the pump to the
fitting on the valve. See illustrations below.
STEP 6:
Slide one hose clamp on the end of the 3/4” x 56” hydraulic return hose (2 ) that comes from the fitting on the
filter. Then connect the hose to the fitting on the valve.Tighten hose clamp. See illustrations below.
Area of
Detail
DETAIL A
SCALE 1:3
ITEM NO. PART NO.
DESCRPTION
QTY.
1
39027500
1/2” X 38” Pressure Hose
1
2
39027400
3/4” x 56” Return Hose
1
3
39031600
Worm Gear Clamp
3
STEP 7:
Attach the latch (3) to the bottom side of the beam as shown in the diagram using the two 1/2” x 1-1/4”
Grade 5 hex cap bolts (4), the two 1/2” lock washers (1) and the two 1/2” hex nuts (2 ). Lower the beam
onto the tongue.Position the latch assembly on the tongue and tighten hardware
ITEM NO. PART NO. DESCRIPTION QTY.
1
O/L
1/2” Lock Washer
2
2
O/L
1/2” Hex Nut
2
3
40127500 Beam Lock
1
4
O/L
1/2” x 1-1/4” Bolt
2
O/L- Obtain locally. Common fasteners available
through hardware and farm stores.
Page 9
