E
N
G
L
I
S
H
Speedaire Operating Instructions and Parts Manual
Model 1WC94
11
1. Hold “quadraport” and
pull quick-connect coupler
(D) back to release and
remove as shown in
Figure.
2. Attach one end of a 1/2”
hose (E) with 3/8” quick-
connect back flow safety
check valve (provided in
kit) as shown in Figure.
Make sure quick-connect
coupler is secure.
To prevent
possible injury, ALWAYS
use back flow safety
check valve included with
unit to connect “quadra-
port” to hose for use at a
remote location. If
replacement back flow
safety check valve is
needed refer to the Parts
pages.
NOTE:
Always use pipe
sealant tape when connect-
ing hoses or fittings to pre-
vent air leaks.
NOTE:
Always use pipe
sealant tape when connect-
ing hoses or fittings to pre-
vent air leaks.
TO OPERATE
“QUADRAPORT” AT A
REMOTE LOCATION:
Can cause
serious injury or death.
Tank may contain 175 PSI
of air pressure. Never con-
nect accessories to unreg-
ulated air. Never operate
tools or accessories above
marked maximum pres-
sure.
Reduce air
pressure in tank to 60 psi
maximum before remov-
ing or connecting
“quadraport” and when
connecting hose to tank
quick-connect coupler.
A
B
C
D
D
E
3. Attach the other end of
the 1/2” hose (E) with 3/8”
universal quick connect
body to the “quadraport”
as shown in figure.
NOTE:
See Figure below to
assemble 3/8” universal quick
connect body to hose.
4. Attach 3/8” hoses (A)
with 1/4” industrial quick-
connect plugs (B) to the
outlets (C). One to four
tools can be used at the
same time.
5. The “quadraport” can be
temporarily or perma-
nently mounted at the
work site using the three
mounting holes (F). See
Figure.
E
F
Installation
(Continued)
