6
ASSEMBLY INSTRUCTIONS
1. Positioning of the air compressor (Fig A):
a. Position the air compressor (1) near an electrical outlet (2).
b. The compressor must be at least 12" (31 cm) from any wall (3)
or obstruction, in a clean, well-ventilated area to ensure sufficient
air flow and cooling.
c. Place the air compressor on the floor or a hard, level surface.
The air compressor must be level to ensure proper drainage.
2. Connect air hose to compressor (Fig B):
Connect the air hose (1) to the compressor’s quick coupler (2) with the
quick connector (3).
Fig A
Fig B
Fig C
NOTE: Air hose and quick connector are not provided and need to be
purchased separately. Apply plumber's tape on all threads
to prevent air leakage.
WARNING
CAUTION
To avoid personal injury, always shut off and unplug the unit and relieve
all air pressure from the system before performing any service on the
air compressor.
Escaping air and moisture can propel debris that may cause
eye injury. Wear safety glasses when opening the drain valve.
Risk of unsafe operation. Unit cycles automatically when power is on.
When performing maintenance, you may be exposed to voltage sources,
compressed air or moving parts. Personal injuries can occur. Before performing
any maintenance or repair, disconnect power source from the compressor and
bleed off all air pressure.
MAINTENANCE /
REPAIR
TROUBLESHOOTING
OPERATION
ASSEMBLY /
INSTALLATION
S
A
FET
Y
/
SPE
C
IFI
C
A
TIO
NS
GETTING STARTED
12 / 31 cm
(1)
(1)
(2)
(2)
(3)
(3)
3. Attaching the air filters (Fig C):
a. Insert the threaded end of
b. Rotate clockwise to tighten.
Hand tighten only.
(4)
the air filters (4) into the
threaded port of the pump
head. Do not apply thread
tape to the air filter
assembly's threads.
