Troubleshooting 28
TROUBLE SHOOTING
Q: Why did the “
NO SENSOR
” message appear even though my sensor was
connected?
Please check if the sensor cable and the device cable are porperly and securely
connected. Make sure that the arrows on the cable heads align with each other,
and then insert the plug into the receptacle until you hear a click.
Also, the connection must be made before the power is switched on; otherwise,
the sensor will not be recognized by the device.
Q: How come the lean angle meter needle was not moving during the ride?
Please make sure the sensor is connected. Check to see if the “UP” lettering is
pointing upward and “FRONT” to the front of the bike. It must be parallel to the
longitudinal center line of the motorcycle body and vertical to the ground.
Q: The lean angle measured was smaller or larger than the actual angle?
Please check to see if the sensor is installed with the correct orientation (see
above). Make sure the installation location does not move, turn, swing, wag, or
vibrate too much. For more information, please see the Installing Sensor section.
Make sure you are using the red sponge tape included in the box to install the
sensor. Do not use the Dual Lock tape. It will create extra vibration.
Please also make sure that the environmental temperature is within 36°F ~140°F
(2°C ~ 60°C). Using GMOS outside its operating temperature range might affect
measurement accuracy.
Q: Why was the lean angle history not updated after I finished a turn?
There are two possibilities. The first is that your speed of the turn did not exceed
your Angle Threshold. As a result, the angle was ignored and was not recorded.
To adjust the Angle Threshold setting, please go to System Menu.
The other is that the vibration when you were leaning was too much. As a result,
the angle was categorized as invalid by GMOS Noise Filter. If the vibration was
not caused by road shock, please check if the sensor was installed securely and
if the installation location swings or moves. If necessary, install the sensor to a
location with less vibration.
4
