6
ENGLISH
16. Calibrate the flow control setting. (See figure 10).
a. Push flow control arm to "OFF" position.
b. Slide flow control mounting bracket along tube until
closure plate in bottom of hopper just closes.
c. Snug the 1/4" nylock hex nuts just enough to hold
flow control mounting bracket in place.
d. Set adjustable stop at "5". Pull flow control arm
against stop. Verify that closure plate has opened
about half way.
e. If closure plate does not open half way, adjust
position of flow control mounting bracket until closure
plate will open about half way at "5" and will close
completely in the "OFF" position.
Tighten
the 5/16"
nylock hex nuts.
FIGURE 10
FLOW
CONTROL
ARM
OFF
ON
1
2
3
4
6
7
8
9
10
5
ADJUSTABLE
STOP
(SETTING "5")
ON
OFF
0
FIGURE 8
FIGURE 9
13. Assemble the two
INNER
hitch braces to the flow control
mounting tube using a 1/4" x 1-3/4" hex bolt and a 1/4"
nylock hex nut.
DO NOT TIGHTEN YET
. See figure 8.
14.
TIGHTEN
all nuts and bolts assembled up to this point.
Do not collapse the tubes when tightening.
15. Assemble the hopper strap to holes in top of hopper
using two 1/4" x 2" hex bolts, small washers, nylon
washers, and 1/4" nylock nuts. See figure 9.
1/4 x 1-3/4
HEX BOLT
1/4 NYLOCK NUT
1/4-20 x 2 HEX BOLT
1/4 NYLOCK NUT
SMALL WASHER
NYLON WASHER
