RugBuddy
™
Portable Heater for under your Area Rug!
Models: USC.1410.11.120 ∙ USC.940.11.120 ∙ USC.470.11.120
Speedheat® is Floor Heating
NON-SLIP
AND
INSULATION
PADDING
* IMPORTANT
!
*
Y
OU
M
UST
USE A
R
UG
Y
OU
M
UST
USE A
RUG
OR
1.
For best results:
•
If area rug is
placed over a hard surface, such as ceramic tile or wood, a non
used for thermal insulation that exceeds 1/8 inch.
•
If area rug is placed over a soft surface, such as wall
padding should be used a
nd may be less than 1/8 inch.
o
The cushion or padding should be trimmed to be 1 inch smaller than area rug on all four
sides.
2.
Place the cushion or pad in the desired position on top of the existing floor covering.
3.
If the floor covering
is c
eramic
be used to ensure acceptable heating performance
your convenience, or
you may use any non
prefer.
Note:
There is no top or bottom and cord comes out of the corner.
Cord is 6 feet long and connects to GFCI plug.
USC.470.11.120 ∙ USC.370.11.120 ∙ USC.165w.11.120 ∙ USC.165L.11.120 ∙ USC.065.11.120
PADDING
SPECIFICATION
AND
INSTALLATION
UG
P
AD
UNDER YOUR
R
UG
B
UDDY
™!
OR
CARPET
ON TOP OF YOUR
R
UG
B
UDDY
™!
placed over a hard surface, such as ceramic tile or wood, a non
used for thermal insulation that exceeds 1/8 inch.
If area rug is placed over a soft surface, such as wall
-to-
wall carpeting, a non
nd may be less than 1/8 inch.
The cushion or padding should be trimmed to be 1 inch smaller than area rug on all four
Place the cushion or pad in the desired position on top of the existing floor covering.
eramic
tile
and
installed
over a concrete slab,
a thermal
be used to ensure acceptable heating performance
of the
RugBuddy™.
Speedheat® offers these for
you may use any non
-
slip thermal insulation padding for area rugs
There is no top or bottom and cord comes out of the corner.
Cord is 6 feet long and connects to GFCI plug.
Operating Instructions
and Safety Advice
∙ USC.065.11.120
Page 2 of 5
placed over a hard surface, such as ceramic tile or wood, a non
-slip pad should be
wall carpeting, a non
-creep cushion or
The cushion or padding should be trimmed to be 1 inch smaller than area rug on all four
Place the cushion or pad in the desired position on top of the existing floor covering.
a thermal
insulation pad must
Speedheat® offers these for
slip thermal insulation padding for area rugs
that you