RugBuddy
™
Portable Heater for under your Area Rug!
Models: USC.1410.11.120 ∙ USC.940.11.120 ∙ USC.470.11.120
Speedheat® is Floor Heating
RugBuddy™
H
EATING
P
ANEL
I
NSTALLATION
1.
Place the heating panel over the cushion or pad in the desired position, ensuring that
C
OMPLETELY
F
LAT
with
NO CREASES
Note:
•
For best results, cushion pad should be at least 1 inch larger than the heating panel on all four
sides. If it is not,
D
O
N
OT
may be required.
•
There is no top or bottom of the
is most convenient for your installation.
•
The power supply cord
kept clear of walkways
,
2.
S
ECURE THE
P
ANEL
to the pad or cushion with a strong adhesive tape at each corner and in at least one
additional place along each edge.
T
APE AT
:
Each corner
At least one additional place along each edge.
N
OTE
:
•
The supply cord must never be plugged in und
•
The supply cord must never be looped under the area rug to
take up excess length.
•
Additional protective layers are necessary for reversible and
extremely high value rugs. Heating panels should not be
placed under irreplaceable rugs.
IMPORTANT!
•
Never
fold or roll up
•
DO NOT allow heater
or
folds
!
•
Do not forcefully remove heater from pad and rug. If adhered
to either, simply turn on
minutes.
At this time, the heater should be able to be easily
removed from both pad and rug.
USC.470.11.120 ∙ USC.370.11.120 ∙ USC.165w.11.120 ∙ USC.165L.11.120 ∙ USC.065.11.120
NSTALLATION
Place the heating panel over the cushion or pad in the desired position, ensuring that
NO CREASES OR FOLDS
.
For best results, cushion pad should be at least 1 inch larger than the heating panel on all four
OT CUT THE HEATING PANEL
.
Unless negligible, a different
There is no top or bottom of the
RugBuddy™.
You can
flip the heating panel whichever way
is most convenient for your installation.
The power supply cord
is 6’ long, flat,
and located in the corner of the heater
,
so that people do not trip over the cord.
to the pad or cushion with a strong adhesive tape at each corner and in at least one
additional place along each edge.
At least one additional place along each edge.
The supply cord must never be plugged in und
er the area rug.
The supply cord must never be looped under the area rug to
Additional protective layers are necessary for reversible and
extremely high value rugs. Heating panels should not be
placed under irreplaceable rugs.
or roll up the RugBuddy™ while in operation!
heater it to operate unless it is
completely flat
Do not forcefully remove heater from pad and rug. If adhered
to either, simply turn on
RugBuddy™
for approximately 5
At this time, the heater should be able to be easily
removed from both pad and rug.
Operating Instructions
and Safety Advice
∙ USC.065.11.120
Page 3 of 5
Place the heating panel over the cushion or pad in the desired position, ensuring that
H
EATING
P
ANEL
I
S
For best results, cushion pad should be at least 1 inch larger than the heating panel on all four
Unless negligible, a different
RugBuddy™
size
flip the heating panel whichever way
and located in the corner of the heater
. This should be
to the pad or cushion with a strong adhesive tape at each corner and in at least one
completely flat
with
no creases
