RugBuddy
™
Portable Heater for under your Area Rug!
Models: USC.1410.11.120 ∙ USC.940.11.120 ∙ USC.470.11.120
Speedheat® is Floor Heating
OPTIONAL ACCESSORIES
Controls
Timers
A 120V, grounded timer
(These can be purchased at your local hardware
PlugBuddy™ Plug-in Thermostat
The
PlugBuddy™
plug-in thermostat
programmed to operate your
it on or off.
IntuiStat™ (Hard-Wired)
If you would like to install a hard
http://www.speedheat.us
KlimaGrip™
(optional rug pad by Speedheat® available for purchase in lieu of your own non
NOTE:
You must
tape your RugBuddy™ to a non
However, it does not have to be the KlimaGrip™ by Speedheat®. Feel free to use any non
NEVER operate
the RugBuddy™ without it being
KlimaGrip™ Installation Instructions
On Hard Surfaces
1. Remove Plastic
Protective Cover
2. Place the Dark Side of
the Pad Down on the
Floor.
USC.470.11.120 ∙ USC.370.11.120 ∙ USC.165w.11.120 ∙ USC.165L.11.120 ∙ USC.065.11.120
can be used with the
RugBuddy™
.
hese can be purchased at your local hardware or home improvement store)
in Thermostat
in thermostat can be plugged into your wall and
programmed to operate your
RugBuddy™
without having to worry about turning
)
If you would like to install a hard-wired thermostat, please visit our website at
http://www.speedheat.us to order or for installation instructions.
pad by Speedheat® available for purchase in lieu of your own non-slip rug pad)
tape your RugBuddy™ to a non
-slip RUG PAD
.
However, it does not have to be the KlimaGrip™ by Speedheat®. Feel free to use any non
the RugBuddy™ without it being
FLAT with no creases & S
ecured to a non
KlimaGrip™ Installation Instructions
(optional add-on)
On Hard Surfaces
Remove Plastic
Protective Cover
Place the Dark Side of
the Pad Down on the
Floor.
Operating Instructions
and Safety Advice
∙ USC.065.11.120
Page 5 of 5
without having to worry about turning
wired thermostat, please visit our website at
slip rug pad)
However, it does not have to be the KlimaGrip™ by Speedheat®. Feel free to use any non
-slip pad.
ecured to a non
-slip rug pad.
On Carpeting
1. Remove Plastic
Protective Cover
2. Place the White Side
of the Pad Down on
the Carpet.
