08
Speedway leger User Manual
1) Productunfolding
1. Raise the handle post
(Steering tube)
2. Adjusting the height
of the handle T-Bar
3. Spread handle T-bar
Press the folding lever
down to release
the handle.
Press the fixing groove to adjust
the height of the handlebar,
and then secure the QR lever.
How to use the product
2) How to start
Things to check before power on
Before turning the product on, turn on
the power with the LED lamp button
turned off.
After tilting the kickstand, find a stable
position on the footrest and then hold the
handle grip comfortably. Be careful not to
raise your foot on the rear fender.
Step3. Stance for driving
Acceleration can be performed by using the
throttle of the instrument panel while driving,
and the deceleration or stop can be performed
by holding the brakes on the handle.
Step 4. Acceleration and deceleration
Side stand
If the headlight button is pressed before the product
is turned on, the instrument panel will not turn on.
In this state, it is designed not to start.
(Built-in short-time theft prevention function)
* The power of the instrument panel will turn off
automatically after a few minutes of inactivity.
At this time, the LED lamp is also turned off, so
turn it off with the LED lamp button when you
turn it on again, and turn off the main power
switch after use.
Step1. Check before power on
Press the POWER button on the instrument
panel for 2 seconds to turn it on.
You can set the start mode, cruise mode,
electronic brake, and ABS function.
Step2. Turning on the instrument panel
Rear fender
Brake
Index finger
throttle
Tip
Before driving, be sure to check the folding part, the handle part,
and the part where the main fixing part of the product
are all fastened well.
And check the position of the fixing slide, the QR lever locking status, and the folding part fixing status
Throttle malfunction caution
Regardless of whether the throttle is operated or not, the motor sensor may continue to operate, causing
malfunctions such as sudden acceleration.In this case, hold the brake lever to cancel the operation.
This phenomenon may be caused by corrosion of the throttling, immersion of the throttle, disconnection
of the magnet, broken off levers, or breakage of the spring. Do not bounce the throttle lever strongly.
DANGER
WARNING
CAUTION
NOTICE
DANGER
Open the handlebar.
