Spektrum Air Module
10
Spektrum Air Module
11
4. Connect the antenna’s fitting to the module, screwing it securely in place.
Important: Never operate the module without the antenna
connected. Doing so could overload the internal electronics and
could cause a failure.
5. Turn on your transmitter. The LED on the back of the module should come
on after a few seconds. If not check to be sure the transmitter is in PPM
modulation mode (Step 3 in preparing the transmitter above).
The Module system is compatible with all Spektrum DSM2 receivers that
includes the AR7000 and AR9000 full-range receivers.
Note
: An optional Flight Log RF data recorder is available. The Flight Log
records RF link flight data and displays this information onscreen, allowing
you to evaluate the RF link performance of each individual receiver. See
page 25 for more details about the optional Flight Log RF data recorder.
Installing the Receiver
Installing the AR7000
The AR7000 incorporates dual receivers, offering the security of dual path RF
redundancy. An internal receiver is located on the main PC board, while a second
remote receiver is attached to the main board with an extension. By locating these
receivers in slightly different locations in the aircraft, each receiver is exposed to its
own RF environment, greatly improving path diversity (the ability of the receiver to
see the signal in all conditions).
Installation
Installing the JR Module
1. Carefully install the Spektrum module into the transmitter paying close
attention to properly align the pins.
2. Turn on your transmitter. The LED on the back of the module should come
on after a few seconds. If not check to be sure the transmitter is in PPM
modulation mode (Step 3 in preparing the transmitter above).
Summary of Contents for DSM
Page 1: ...Air Module System ...
