S4H-RE-00, S4H-RE-10
7
3.4.b. Press
Send to device
to send the data for WiFi relay
initialization to your AP/router.
The data must be sent while the red LED 3 on the sensor
illuminates red.
5.
Connection of the Wi-Fi relay to your Smartphone/tablet is indicated by LED 3 flashing
red. The duration of this connection is limited to 3 minutes, during which you must send the
initialisation data from your Smartphone/tablet to the Wi-Fi relay.
6.
Once configured, the Wi-Fi relay makes attempts to connect to the cloud.
LED 3 illuminates orange while the Wi-Fi relay connection to your AP is being established.
Connection of the Wi-Fi relay to the cloud is indicated by LED 3 flashing orange.
7.
Once the Wi-Fi relay has connected to your home AP and then to the cloud, LED 3 starts
illuminating green.
8.
Close the Wi-Fi relay box with cover 2.
9.
Now the device is ready for use.
10.
Test the connection between the Wi-Fi relay and your smartphone/tablet by switching
each relay on and off from the Smart4house application (after performing the steps described
below).
Note: Once the Wi-Fi relay has been successfully initialised, the provisional Smart4house
network should vanish and your Smartphone/tablet should automatically switch to your AP
network. To make sure that this procedure occurred, follow these steps:
Click on the Smartphone button to open the home screen; click on the Settings icon; and on the
Settings screen click on the Wi-Fi icon. The network of your AP should be active on the Wi-Fi
screen. If this has not taken place automatically, connect by clicking.
To check the WiFi relay's functionality, proceed as follows: Clicking on the
icon will get
you to the screen with the list of active devices. Clicking on the particular device will get you to
the "Detail" screen. On this screen you can control output relays of the WiFi relay.
Activity of relay Re1 is indicated by the LED1 control illuminating, activity of relay Re2 is
indicated by the LED2 control illuminating. The COM and NO terminals are connected in the on-
state, the COM and NC terminals are connected in the off-state.
