A direct connection requires a non-standard cable where the wires are not
run straight through. Please refer to the two cable ends shown below in
figure 4.
Figure 4 – Crossover Cable for Direct Connection
A standard connection through a hub, switch, or network uses a standard
CAT5 patch cable. Please refer to the two cable ends shown below in
figure 5.
Figure 5 – Standard Straight Through Cable – Standard CAT5 Patch
1
1
1
1
118080-001 REV A
Page 7 of 95
Summary of Contents for SLM SERIES
