View the screen as a “left” and a “right” with the right half
containing status read from the SLM and the left half
containing the values that are programmable by the user.
For any programmable setting you click on the button to the
left of the setting, which brings up the program set point
screen. For example, click on the button labeled, ‘V’ to set
the output voltage set point. Refer to figure 12.
4.2.2.4
Program Set Point Screen
.
Figure 12 - Program Configurable Values Screen
The field is the scaled value or real world value. Enter the desired
set point level within the shown range.
The user can then click Apply to send the set point to the SLM and
remain in the set point screen, or click OK to send the set point and
close the set point entry window. The user may also click on
Cancel to close the window without sending any changes.
To reset the Total hour On meter to zero via the Applet a password
is required.The password is
“SHV_Reset”
4.2.2.5
Java Warning Messages
You may notice a message at the bottom of all dialog windows that
are displayed from the SLM Control and Monitor Applet. The
wording may vary slightly depending on the JVM version but on
some the message is “Java Applet Window”. This message informs
the user that the dialog window was generated by an applet. The
design philosophy for the JVM was for secure computing, so the
origins of new windows are supposed to be as obvious as possible.
118080-001 REV A
Page 16 of 95
Summary of Contents for SLM SERIES
