Reply from 192.168.1.4: bytes=32 time<1ms TTL=64
Reply from 192.168.1.4: bytes=32 time<1ms TTL=64
Reply from 192.168.1.4: bytes=32 time<1ms TTL=64
Reply from 192.168.1.4: bytes=32 time<1ms TTL=64
Ping statistics for 192.168.1.4:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip times in milli-seconds:
Minimum = 0ms, Maximum = 0ms, Average = 0ms
4.2.4 Configuring the SLM For a Local Area Network (LAN)
If you have chosen to place the SLM onto your local area network
you will need:
•
A CAT5 network patch cable to physically connect the SLM
to the LAN
•
A static IP address to assign to the SLM.
Remember that even if the IP address you have selected is in
general a valid IP address it needs to be valid for your LAN (local
area network). Otherwise the device will not be accessible from an
Internet browser or Ping.
4.2.4.1
Configuring the Network Settings from the
Monitor and Configure Applet
The network settings are configurable from the Network Settings
tab, refer to figure 21.
118080-001 REV A
Page 25 of 95
Summary of Contents for SLM SERIES
