21
Manual Datalogging
1. Set the sampling time to 0 seconds. Refer to page 15.
2. Press
REC
. “REC” will appear on the LCD.
3. Press
LOGGER
. “DATALOGGER” will flash on the LCD
and the alarm will sound while the measurement data
and time information are saved to memory. The position
(location) number will appear on the bottom of the LCD and
will also be recorded on the SD card.
Note…
To enable/disable the touch-tone feature, see page 10. Press ▲
or ▼ to set the position number (from 1 to 99). To indicate the
position location, P x (x = 1 to 99) will appear on the lower display.
4. To finish datalogging, press
REC
for longer than 2 seconds.
“REC” will disappear from the LCD to indicate that
datalogging has ended.
SD Card Data Structure
1. The first time a SD card is used in this meter, a folder
PHA01 will be generated.
2. If the datalogger is being used for the first time, a new file
PHA01001.XLS will be generated under the route PHA01\.
After exiting the datalogger and executing the function
again, the data is saved to the PHA01001.XLS file until the
data reach 30,000 data columns. A new file will then be
generated (i.e., PHA01002.XLS).
Summary of Contents for 850060
Page 1: ...PH SD Card Datalogger 850060 Instruction Manual ...
Page 27: ...27 Excel Data Screen Excel Data Screen ...
Page 28: ...28 ...