15
U s e r I n s t r u c t i o n s - E n g l i s h
Cleaning and Storage
Basic care of all Miller Fall Protection equipment will prolong the life of the unit and will contribute toward the
performance of its vital safety function. Proper storage and maintenance after use are as important as cleansing
the equipment of dirt, corrosives, or contaminants. Clean system components using a cloth dampened with water
and mild soap or detergent and towel dry. Storage areas should be clean, dry and free of exposure to fumes or
corrosive elements.
Servicing
Servicing must only be carried out by a qualified person trained in the inspection and replacement of the system.
A record log of all servicing and inspection dates for this system must be maintained.
This system and all its
components and devices must be withdrawn from service if subjected to fall arresting forces.
Only original
Miller Fall Protection replacement parts are approved for use in this system. Contact Miller Technical Services at
800.873.5242 if you have any questions.
8.0 Inspection and Maintenance
Inspection
The Vi-Go System is designed for today’s rugged work environments. To maintain its service life and high
performance, all components should be inspected frequently. Visually inspect before each use. Regular
inspection by a competent person for wear, damage or corrosion should be a part of your safety program.
Replace equipment if any of the defective conditions explained in this manual are found.
System Inspection
Before each use, visually inspect for the following:
Inspect all components for physical damages, cracks, wear and corrosion.
•
Check fasteners, bolts and pins for damages, cracks, wear and corrosion.
•
Inspect the cable lifeline for cuts, frays, kinks, broken strands or other signs of unusual wearing patterns.
•
[CAUTION: Always wear gloves when inspecting wire rope!]
Check cable tension ensuring there is no slack. Retension cable to specifications as per section 5.5 of this
•
manual.
Inspect for malfunctioning components, broken or missing springs and fasteners.
•
[For replacement parts call: 800.873.5242]
Inspect cable sleeve, connector and full-body harness according to the manufacturer’s instructions.
•
Labels
LB1019 REV. A
WARNING
Manufacturer's instructions supplied with this product
at the time of shipment must be followed. Failure to
do so may result in serious injury or death.
Climbing System
3
4
2
1
TO SYSTEM MUST NOT EXCEED
NUMBER OF USERS ATTACHED
SYSTEM CAPACITY RATING
1
2
4
3
D
J
YR
F
M
J
J
A
M
N
O
A
S
PUNCH DATE OF INSTALLATION/INSPECTION
6
5
Sperian Fall Protection, Inc.
Franklin, PA. U.S.A.
Call: 800-873-5242
Vi-Go
200%
OSHA 1926.502,
1910.27, ANSI A14.3,
CSA Z259.2.1-98
(Class AS)
Summary of Contents for MILLER Vi-Go
Page 1: ......
