background image

SPECIFICATIONS

SP–10A

SENSITIVITY

2 k

/V AC & DC

AC V

10/50/250/500

DC V

10/50/250/500

DC MA

250

OHMS FULL RANGE

1K/10K/100K

OHMS MID SCALE

5/50 /500

dB

-20 T0 +56

SPECIAL FEATURES

SEPARATE 1.5V TO 9V

BATTERY CHECK RANGES

ACCURACY

DC ± 3% FS - OHMS ± 3% OF ARC

INDOOR USE 
TEMPERATURE 5

0

C TO 40

0

C

MAXIMUM RELATIVE HUMIDITY 80% @ 31

0

C

MINIMUM 50% @40

0

C

BATTERY

COMMERCIAL ELECTRIC ™ PART # B - 1, TYPE AA, 1.5VDC 

FUSE

COMMERCIAL ELECTRIC ™ PART # F - 7. MINIATURE GLASS    

TYPE, 5x20MM1/2 AMP, 250VAC, FF

DIMENSIONS

4”H x 2.9”W x 15/16”D (100H x 63W x 34DMM)   

WEIGHT

3.6OZ. (102GMS)          

TEST LEADS

TL-34

ONE YEAR LIMITED WARRANTY

A.W Sperry Instruments Inc. warrants that this A.W Sperry Instruments Inc. has been carefully tested,
inspected and warranted for one (1) year from the date of purchase by the original end user, provided the
instrument has not been misused, damaged due to negligence, neglect or unauthorized repair, abused or
used contrary to the operating instructions.

Instruments and proof of purchase in the form of a legible copy or original of the sales receipt clearly
identifying the distributor, model number and date of purchase must be returned to A.W Sperry
Instruments Inc., Attention: Customer Service Center, 245 Marcus Boulevard, Hauppauge, NY 11788
postage prepaid for examination and verification of manufacturing defect under warranty. A.W Sperry
Instruments, Inc. shall be the sole judge of such defect. The liability of A.W Sperry Instruments, Inc. shall
be limited to the repair or replacement at its sole option of any defective product.

THIS WARRANTY AND THE OBLIGATIONS AND LIABILITIES OF SELLER THEREUNDER ARE
EXCLUSIVWE AND IN LIEU OF AND BUYERS HEREBY WAIVES ALL OTHER REMEDIES, EXPRESS
WARRANTIES, GUARANTEES OR LIABILITIES OF AND FOR INCIDENTAL OR CONSEQUENTIAL
DAMAGES OR WHETHER OR NOT OCCASIONED BY SELLER’S NEGLIGENCE. THIS WARRANTY
SHALL NOT BE EXTENDED, ALTERED OR VARIED EXCEPT BY A WRITTEN INSTRUMENT SIGNED
BY SELLER AND BUYER. SOME STATES ALLOW LIMITATIONS ON HOW LONG AND IMPLIED
WARRANTY LASTS, SO THE ABOVE LIMITATION ON HOW LONG AN IMPLIED WARRANTY LASTS,
SO THE ABOVE LIMITATIONS MAY NOT APPLY TO YOU. THIS WARRANTY GIVES YOU SPECIFIED
LEGAL RIGHTS AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY STATE TO STATE.

2

OPERATING

ENVIRONMENT

Instrument complies with insulation category (over voltage category II)

Pollution degree 2 in accordance with IEC-644

This equipment has been evaluated to INSTALLATION CATEGORY (OVERVOLTAGE
CATEGORY II)

Summary of Contents for SP-10A









Reviews: