8000D Mixer/Mill
Page 5 of 21 SPEX CertiPrep 8.21.03
SN and Higher
3. UNPACKING
Any visible damage to the shipping container should immediately be reported to the carrier. If
there is no visible damage, remove all packing documents from the exterior of the box, and after
completion of your inspection, file with your records.
Open the top of the shipping box. Remove the foamed-in-place packing material. Carefully grasp
the straps on the mill from both sides, exercising caution while using proper lifting techniques to
remove the unit from the carton (the unit weighs 68 lbs). Place the mill on the bench top where it
will likely stay, and open the lid. Look for any hidden damage that may have occurred during
shipping.
Follow a logical sequence of steps as you inspect the unit (see Figure 2). For example:
1. Inspect the outside of the cabinet for any visible damage.
2. Are any of the switches damaged?
3. Is the latch mechanism damaged?
4. Inspect the interior of the mixer.
5. Is the motor damaged?
6. Do all the springs and mounting points seem okay?
7. Inspect the accessory pack. Compare with the packing list.
If everything seems to be okay, proceed to the section, “ SETTING UP,” on page 11
Lid Assembly
Control Panel
Electrical Inlet
Module at back
(Figure 2)
8000D Mixer/Mill
