Sphere 8 Series, Instruction Manual

ANT IN

DTV

ANT IN

Coaxial

Earphone

Mini YPbPr

Mini AV

PC AUDIO

CI

SAT

CVBS

LINE OUT

ARC IN

OUT

There are two selections:  ON and  OFF ,when you choose  ON ,you can operate a compatible HDMI-CEC 

controlled device.

There are two selections: ON or OFF, it is avaliable when the Speaker Preference is set to Amplifier.  When 

selected to ON, sound from will be heard, when selecting OFF, no sound from the Amplifier will be heard.

This TV is fitted with the worldwide standard IC solution for ARC compatibility. There may be some slight 

compatibility issues in head units with non-standard IC solutions installed. You may need to switch the 

Head Unit off/on again in order for ARC to reconnect in some cases.

C

Digital Audio output for surround sound/sound bars etc.

Coaxial

：

Digital Audio output for surround sound/sound bars etc.

Earphone

：

Component Video in.

Mini YPbPr

：

Connect the PC audio output of the PC to the Audio input 

jack on the TV.

PC audio

：

Common Interface Input

CI

：

Insert the USB flash drive into the USB slot on the TV.

This slot can also be used to supply power for HAKO 

Android TV box.

USB

：

Composite Video & Audio in.

Mini AV

：

Power

：

Connect the AC power pack or 3M 12V RV lead to 

the 12VDCIN connection on the TV.

CVBS OUT:

This mirrors the Video Signal from Input 12 (A/V) ONLY. 

The output is Video only.

LINE OUT:

Audio output for external devices such as Head Units, amplifiers etc.

HDMI

：

Connect the HDMI output of the accessory device to the HDMI 

input on the TV. Select the HDMI input source using the 

INPUT button on the remote.

VGA:

Connect the RGB output of the PC to the VGA input on the TV.

ANT IN:

Connect the antenna to the RF IN connection. Please refer to the

QRWHV

below.

EC:

Ampli

Į

er  Support  ARC:

Thank you very much for your purchase of this product. Please read this manual carefully and keep it safe for reference.

Please use the power cord designated for the product. When an extension cord is required, use one with the correct 

power rating. The cord must be grounded. The product should be installed on a flat surface to avoid tipping. Space 

should be maintained between the back of the product and the wall for proper ventilation.If you would like to mount

the TV to the wall, please see “Preparing the LED for Wall Mounting”below for additional information. Avoid installing

 the product in the kitchen, bathroom or other places with high humidity.

The HDTV can either be kept on the stand or mounted to the wall for viewing. If you choose to 

mount the HDTV to the wall, please follow the instructions below.

Unplug all the cables and cords from your LED TV.

Place the LED TV face down on a soft and flat surface(blanket,foam,cloth,etc) to prevent any 

damage to the display.

Remove the stand screws allowing the stand to be removed.

The mounting bracket is made up of two parts-the wall bracket and the TV bracket. Attach the TV bracket to the TV via 

the included screws.

*

ncluded with your wall mount kit(Please check the instruction manual of the wall mount for further 

information)

Attach the wall bracket to the wall with appropriate screws. Ensure the wall is

suitable to hold the weight of 

the TV. (Please check the instruction manual of the wall mount for further information)

Slide the TV bracket into the wall bracket

Ensure the wall mount is secured and locked in travel position when the RV is in transit

RESET: 

Like any product controlled by microprocessors this TV may hang or become

unresponsive.

*

n the unlikely 

event this occurs simple disconnect the power and reconnect after 10 seconds.

REMOTE:

 To prevent leakage which may result in bodily harm or damage to the remote:

1. Install AAA batteries correctly, and make sure polarities are correctly aligned with the battery 

compartment markings.

2. Do not mix batteries (OLD and NEW or CARBON and ALKALINE,etc)

3. Remove batteries when the remote is not used for a long time.

DLJŵƵƐŝĐ͕ŵŽǀŝĞŽƌŝŵĂŐĞĮůĞƐĚŽŶŽƚĚŝƐƉůĂLJ͍

Due to the large variation of file sizes, compression formats and codec available,playback of all files 

cannot be guaranteed.

/ĐĂŶŶŽƚƌĞĐŽƌĚŽŶƚŽŵLJh^ŇĂƐŚĚƌŝǀĞ͍

FAT 32 formatted flash drive is required. 

dŝŵĞ^ŚŝŌĨƵŶĐƟŽŶĂůŝƚLJĚŽĞƐŶŽƚǁŽƌŬ͍

FAT 32 formatted flash drive is required

tĂƌŶŝŶŐ͊ŽŶŽƚŬĞĞƉŝŵĂŐĞƐŽŶƚŚĞƐĐƌĞĞŶĨŽƌĂůŽŶŐƟŵĞ

To prevent the screen from burn in, do not leave static images including menu screens displayed for a period of time. 

Burn in is not covered under warranty provision. 

ATTENTION: 

Do not try to update the TV unless directed by a service technician. Product misconfigured by an 

incorrect update is not covered under warranty.