SnapServer/MOBOTIX Installation Guide
10400783-001
©2016 Sphere 3D Corp.
Page 3 of 9
5.
for the other drive assembly and both blanking trays.
6.
Close the SnapServer
door
.
3. Appliance Connections
All cabling ports, power connections, and exhaust vents are located on the SnapServer rear panel.
1.
Determine the
location
of the management PC, SnapServer NAS, and Power over Ethernet
(PoE) Switch, and then place them where they will reside.
2.
Using one of the two
Ethernet cables
that came in the box:
•
Connect one end of the cable to
Ethernet Port 1
.
•
Connect the other end to a standard
non-POE port
(if available).
3.
for the other
Ethernet cable
for
Ethernet Port 2
.
4.
Attach the power cord into the
AC power socket
on the appliance.
5.
Plug the other end of the
power cord
into a properly grounded AC power source.
6.
Briefly press the front
power button
( ) to power ON the unit.
IMPORTANT: To assure all the cameras are discovered, wait about two minutes until the SnapServer
Status LED is green before proceeding with the camera installation.
4. Camera Installation and Cabling
WARNING:
To reduce the risk of electric shock or damage to equipment, always remove any power
cords while working with the unit.
WARNUNG:
Um das Risiko eines elektrischen Schlags oder Schäden am Gerät zu vermeiden, ziehen
Sie stets den Netzstecker, bevor Sie an der Einheit arbeiten.
AVERTISSEMENT:
Pour réduire le risque de choc électrique ou endommagement de l'équipement,
retirez toujours les cordons électriques en travaillant avec l'appareil.
1 2
Power
Cord
Ethernet
Ports
PoE
Ports
