www.x20.org
- Page 33 of 35 –
- SPI Corp Proprietary and Confidential Information -
6.6 Bypass/Single Yaw
Move the Bypass/Single Yaw switch backward (i.e. setting Single
Yaw mode). Continuously move the left stick to the left and to the
right (i.e. generating YAW command) and verify that black area are
entering the image from both side (by observing the video). When
moving the stick to the left a black area should enter the image from
the right side. When moving the stick to the right a black area should
enter the image from the left side.
Move the Bypass/Single Yaw switch forward (i.e. setting Bypass
mode). Continuously move the left stick to the left and to the right
(i.e. generating YAW command) and verify that the image of the
camera does not change (by observing the video).
Move the Bypass/Single Yaw switch to the center (i.e. setting Bypass
mode). Continuously move the left stick to the left and to the right
(i.e. generating YAW command) and verify that the image of the
camera
does
not
change
(by
observing
the
video).
