USER MANUAL
Page
18
or off.
•
To turn off the laser locator option, press the
M Key
to bring up the main menu, then
press the
▲
,
▼
,
◄
or
►
Keys
to highlight the “Setup Analysis” option, then select
by pressing the
M
or
OK
Keys
.
•
Under the heading named “Laser”, you can toggle between “on” and “off” by pressing
the
◄
and
►
Keys
. Press the
M
or
OK Keys
to confirm your selection.
Caution
–
Laser Safety Warning:
This product incorporates a Class II laser rated at 1mW output at 635nM. Laser
radiation is emitted from the aperture on the front of the product where labeled.
Never point the laser at people or animals – lasers can cause physical injury and
eye damage! DO NOT STARE INTO BEAM! Notify everyone in the area before
operating the laser. Be aware of all surfaces that may reflect laser radiation prior
to use. Do not use this laser with any device that may magnify the laser’s
radiation output such as optical devices. This product complies with IEC60625-1
2001. This product is labeled for safety – DO NOT REMOVE OR OBSCURE
SAFETY WARNING LABELS.
Pausing Live Images and Saving Images
•
To store and save an image, press the
OK Key
to freeze the live image and
temporarily capture the visual image into the built-in flash memory. Pressing the
OK
Key
again will store both the infrared image and visual image into the built-in flash
memory.
•
The frozen image can be defined as the mean (or average of multiple images) of 1, 4,
8, or 16 image frames, which is designed to reduce or eliminate image noise
(distortions) so as to ensure better image quality.
•
The image storage begins when the
symbol appears on the screen. When the
image is saved, “Saved as IMAGE006” (or similar) will appear on the screen
temporarily before the camera returns to the live image display mode selected.
•
If voice annotation is required with the image, make sure that the “Voice Annotat” is
toggled ON before saving and storing the image. To do this, press the
M Key
to bring
up the main menu, then press the
▲
,
▼
,
◄
or
►
Keys
to highlight the “Setup
Analysis” option, and then select the option by pressing the
M
or
OK Keys
