3
2
1
INSTALLING BATTERIES IN THE GYRO FORCE
™
9.? VOLT
1
-
2
-
3
-
3
2
1
STORAGE: The Gyro Force™ should be
stored indoors in the foam tray enclosed in
the box after each use.
Before taking Gyro Force™ back to the
retailer, call our friendly RC technicians at:
1-800-622-8339.
GYRO
FORWARD/
REVERSE
TURBO
CONTROLLER
FORWARD/
REVERSE
Gyro Force™ requires one 9.6-V rechargeable and one 9-V battery to run (Included).
Locate the battery
door on the bottom
of the vehicle.
Unscrew to release
the battery door as
shown.
4
-
5
-
Connect the battery
wire to the car wire
as shown.
Replace the battery
door and tighten the
screw back into
place.
Place the batteries
in the tray according
to the polarity
markings as shown.
1
-
2
-
3
-
Using a Phillips
screwdriver, undo the
hold-down screw and
remove the battery
compartment door.
Place the 9-V
battery in the battery
compartment, making
sure to follow the
c and - polarity
markings.
Replace the battery
compartment door
and refasten the
hold-down screw.
1
-
2
-
3
-
Turn the “ON-OFF”
switch to the “ON”
position.
Use Controller
to move vehicle
forwards or
backwards.
The vehicle steers like a
skateboard. By positioning either
right or left, the vehicle will turn
right and then left/left and then
right. To steer, release the turn
button once the vehicle is pointing
in the direction desired.
GETTING STARTED
Note: If you press right or left while holding the Turbo
button, Gyro Force™ will roll over and perform stunts.
GYRO FORCE
™
GYRO
ROLL WING
BATTERY
DOOR
WHEELS
FRONT
BUMPER
SPOILER
TM
IMPORTANT! PROBLEMS?
BATTERY INSTALLATION
INSTALLING CONTROLLER
9-VOLT BATTERY
Battery
Compartment
Door
Battery
Compartment
Door
Battery
Compartment Door
Turn
Vehicle
Over
9.6-V
Battery
9-V
Battery
Battery
Compartment
Battery
Compartment
