2
3
HOW TO INSTALL BATTERIES
HOW TO CHARGE
HOW TO DRIVE
DRIVING ON WATER
HOW TO FIX DRIFTING
1
2
3
1. Open the battery door with a screwdriver.
(A). If used batteries are present, remove
these batteries from the unit by pulling up on
one end of each battery. DO NOT remove or
install batteries using sharp or metal tools.
2. Install new batteries as shown in the
polarity diagram (+/-) inside the battery
compartment.
3. Replace battery door securely. Check your
local laws and regulations for correct recycling
and/or battery disposal.
1. Turn the vehicle off.
2. Remove the cover by turning the screw or
flipping the latch to the left.
3. Plug the charging cable into a 5VDC
computer outlet.
4. Charging LED indicates charging. Flashing for
charging and ON when fully charged.
5. ALWAYS REMEMBER to return charging
cable and close cover by turning screw or
flipping latch to the right.
1
2
3
4
5
NOTE: If your truck does not connect to the controller the first time, turn the truck off, turn the controller off and repeat
the HOW TO DRIVE instructions.
CONTROLLER NOT CONNECTING
OUT OF RANGE / LOW BATTERY
CONNECTING THE CONTROLLER
1. Turn on the vehicle and place on a flat
surface.
2. Hold the controller near your truck, press
the power button wait until power light
stops flashing.
3. You are ready to drive.
4. Use the remote control to drive.
1
2
3
A
2
NOTE:
THE CHARGING CABLE
STORAGE
COMPARTMENT MUST
BE FIRMLY CLOSED
BEFORE PLAY TO
ENSURE WATER TIGHT
SEAL.
NOTE:
Before driving on water ENSURE THE CHARGING CABLE STORAGE
COMPARTMENT IS FIRMLY CLOSED.
There is no additional preperation required to drive on water.
Fully submerging the vehicle in water is not recommended.
1. Controller will beep when you are close to driving out of
range.
2. Turn and return to you until beeping stops.
3. If beeping continues this indicates low battery.
4. Return and immediately fully charge the vehicle.
