|
© 2017
ONIX Installation Manual |
11
12
REMOTE CONTROL
REMOTE CONTROL
REMOTE CONTROL
REMOTE CONTROL
Speed
Forward / Reverse Function: Press and hold to toggle between each mode.
Natural wind mode: Turn on / off Natural Wind function.
Fan Power Button: Turn on / off the fan.
LED Tone Switch: Toggle between the three LED tones - Cool, Day and Warm.
LED Light On Button: Turns On the LED light.
LED Light Off Button: Turns Off the LED light.
Speed Buttons: Adjust fan speed.
Increase fan speed
Decrease fan speed
Timer Function: Set the timer option with a single press of the button (between 1 hour
to 9 hours). Press and hold to turn off the timer.
Pairing of Remote Control
Firstly, ensure the power supply to the ceiling fan is switched off and the remote is not in use.
Switch on the power to the ceiling fan, you should hear a “beep”.
Within 3 seconds
, press the Power Button to
switch on the fan.
Proceed to press the Timer Button . Upon completing these steps, you will hear a long “beep” from the receiver.
This signals that the remote control has been paired successfully.
However, if you do not hear the long “beep”, please switch off the power source to the ceiling fan and repeat the
above steps again.
Do bear in mind you have to start the pairing
within 3 seconds
of switching on the ceiling fan’s power source.
Speed
Timer
h
Speed
Light
