PulseBlasterDDS
set_freq(1*MHz); // Set register 0
set_freq(2*MHz); // Set register 1
set_freq(3*MHz); // Set register 2
set_freq(4*MHz); // Set register 3
set_freq(5*MHz); // Set register 4
set_freq(6*MHz); // Set register 5
set_freq(7*MHz); // Set register 6
set_freq(8*MHz); // Set register 7
set_freq(9*MHz); // Set register 8
set_freq(10*MHz); // Set register 9
set_freq(11*MHz); // Set register 10
set_freq(12*MHz); // Set register 11
set_freq(13*MHz); // Set register 12
set_freq(14*MHz); // Set register 13
set_freq(15*MHz); // Set register 14
set_freq(16*MHz); // Set register 15
// Start programming the phase registers for DAC_OUT_1
start_programming(PHASE_REGS_0);
// Program the registers in order from 0 to 15
// Units are in degrees
set_phase(0); // Set register 0
set_phase(22.5); // Set register 1
set_phase(45); // Set register 2
set_phase(67.5); // Set register 3
set_phase(90); // Set register 4
set_phase(112.5); // Set register 5
set_phase(135); // Set register 6
set_phase(157.5); // Set register 7
set_phase(180); // Set register 8
set_phase(202.5); // Set register 9
set_phase(225); // Set register 10
set_phase(247.5); // Set register 11
set_phase(270); // Set register 12
set_phase(292.5); // Set register 13
set_phase(315); // Set register 14
set_phase(337.5); // Set register 15
// Start programming the phase registers for DAC_OUT_0 and DAC_OUT_2
start_programming(PHASE_REGS_1);
// Program the registers in order from 0 to 15
// Units are in degrees
set_phase(0); // Set register 0
set_phase(22.5); // Set register 1
set_phase(45); // Set register 2
set_phase(67.5); // Set register 3
set_phase(90); // Set register 4
set_phase(112.5); // Set register 5
set_phase(135); // Set register 6
set_phase(157.5); // Set register 7
set_phase(180); // Set register 8
set_phase(202.5); // Set register 9
set_phase(225); // Set register 10
set_phase(247.5); // Set register 11
set_phase(270); // Set register 12
set_phase(292.5); // Set register 13
set_phase(315); // Set register 14
set_phase(337.5); // Set register 15
//Begin pulse program
start_programming(PULSE_PROGRAM);
9/20/200520
www.spincore.com
