SETTING UP YOUR ISUP
Choose a smooth and clean surface to unfold your board.
-
INFLATE
Make sure that the valve is free of sand or dirt. Unscrew the valve cap. Push button in and turn it
anticlockwise to the left, so that it pops out and is in the "OUT" position.
Connect the pump nozzle into the valve and turn it clockwise. Make sure the pump hose is connected
to the ‘Inflate’ outlet.
Before undertaking a long paddle, inflate the board for a full 24 hours to make sure the board is
airtight. When paddling, the colder temperature of the water may cause a slight loss in chamber
pressure. It is good to carry a pump with you.
Maximum air pressure for this product is 15 psi. Do not use an air compressor.
WARNING: Damage to your board caused by over inflation is not covered by your Warranty.
