Z100080
ZX-1
Operator’s Manual
Spinergy/SMP
Page 11
•
Minimum of
6”
between camber tube and
front caster wheels and footplate.
Control System
The ZX-1 control system consists of a joystick
module and power module. The joystick mod-
ule can be mounted on either armrest and the
power module is mounted on the power base
(Figure 2). The Joystick can be unplugged from
the device by depressing the tab on the two
piece connector cable.
POWER MODULE
The power module provides an interface
between the joystick module, motors,
batteries, and clamshell/actuator (Figure 1).
The power module is connected to the joystick
through the communications cable. It is also
connected directly to each motor and
connected to the batteries through the battery
JOYSTICK
Figure 2.
harness (Figure 12). The battery harness has a
50 amp circuit breaker which protects the
control system electronics from power surges.
JOYSTICK MODULE
The joystick module provides operator
interface for the control system. The joystick
module consists of a joystick, control panel,
and programming/charger port.
The joystick controls speed and direction of
the ZX-1. Move joystick in the direction you
wish to travel. The further away from center
you move the joystick, the faster the ZX-1
will travel. The joystick also controls
engagement/ disengagement of the
clamshell/actuator while in actuator control
mode.
NOTE
•
The ZX-1 will only travel as fast as the
limit set with the Speed Increase button.
CONTROL PANEL
The Control Panel consists of:
•
Battery LED Indicator
•
Power Button
•
Horn Button
•
Speed/Crawl LED Indicator
•
Speed Decrease Toggle Button
•
Speed Increase Toggle Button