Z100080
ZX-
1 Operator’s Manual
Spinergy/SMP
Page 26
WARNING
•
Do not modify ZX-1 without prior autho-
rization from Spinergy. Do not use acces-
sories with the ZX-1 unless accessories
have been pre-approved by Spinergy for
use specifically with ZX-1. Failure to com-
ply could cause injury to operator and
damage to equipment.
•
Do not place ZX-1 into free-wheel mode
while ZX-1 is in use; ensure ZX-1 is in a
safe location on flat ground before entering
free-wheel mode. Failure to comply could
cause injury to operator.
•
Do not operate ZX-1 on public streets or
roadways. Failure to comply could cause
injury to operator, damage to equipment or
traffic citation from local law enforcement.
OUTDOOR DRIVING SURFACES
The ZX-1 is designed to provide optimum
stability under normal operating conditions.
Normal operating conditions are considered
dry, level surfaces composed of concrete,
blacktop, or asphalt.
However, Spinergy recognizes there are also
times when ZX-1 operators will encounter
alternative surface types. For this reason, the
ZX-1 can also handle packed soil, grass, and
gravel as well. The ZX-1 may be used safely
on lawns and in park areas.
Whenever possible, try to avoid the following
terrain and situations:
•
Avoid driving on uneven terrain and/or
soft surfaces.
•
Avoid tall grass that may become lodged in
ZX-1 running gear.
•
Avoid loosely packed gravel and sand.
•
Avoid operating ZX-1 in fresh or salt
water.
•
Avoid using ZX-1 at the edge of a stream,
lake, or ocean.
A safe rule to stand by is...If you feel unsure
about a driving surface, avoid it.
INCLEMENT WEATHER PRECAU-
TIONS
The ZX-1 control system uses industrial-grade
components throughout, ensuring reliable
operation in a wide range of conditions. ZX-1
operators can further improve control system
reliability by keeping extreme exposure to a
minimum.
CAUTION
•
Do not expose control system or other
ZX-1 components to damp conditions for
prolonged periods. Failure to comply could
cause damage to components.
Avoid exposing ZX-1 to inclement weather
conditions. If operator is caught in rain, snow,
severe cold, or heat while operating ZX-1,
calmly proceed to shelter at earliest
opportunity. Once at adequate shelter,
thoroughly dry and clean ZX-1 before storing,
charging, or operating again.
WARNING
•
Store ZX-1 in a dry and clean location.
Failure to comply could cause injury to
operator and damage to equipment.
