Spinning spinner AERO, Owner'S Manual

22

WARNING!

SAVE THESE INSTRUCTIONS

THE MOMENTUM OF THE FLYWHEEL OF THE  BIKE WILL KEEP THE PEDALS TURNING EVEN AFTER 
YOU STOP PEDALING OR IN THE EVENT THAT YOUR FEET SLIP OFF OF THE PEDALS.  DO NOT 
DISMOUNT THE BIKE OR ATTEMPT TO REMOVE YOUR FEET FROM THE PEDALS UNTIL BOTH THE 
PEDALS AND THE FLYWHEEL HAVE STOPPED COMPLETELY.  FAILURE TO COMPLY MAY LEAD TO 
LOSS OF CONTROL AND SERIOUS PERSONAL INJURY.

TESTING THE BIKE

Use this checklist to perform the bike test procedure. 

• Re-check all bolts. Make sure that they have been tightened and that 
there are no missing parts.
• Test the handlebar post and seat post to make sure that they move freely 
and that you are able to lock them securely at different positions.
• Check the saddle to make sure that it is level, tight and does not rotate 
around or tilt. Tighten and adjust as needed.
• Test the seat slider for movement from front to rear, and check it by 
locking it at different settings.
• The brake tension (resistance) can be adjusted using the red resistance 
knob.  Pressing down on the red knob will apply the emergency brake if 
you need to stop quickly.
• Adjust the seat post and handlebar post to your needs.  Refer to the 
playlist at 

https://youtu.be/kiBtxsuzO78

 for video help.   

• Pedal at a moderate pace and test for proper and smooth resistance  
changes while varying the amount of turns on the resistance knob.
• To move the bike after testing is complete, stand in front of the bike, grasp 
the handlebars and tip the bike toward you until the transportation wheels 
are touching the floor.  Roll the bike to the desired location and then gently 
lower the rear of the bike back to the floor.  Be careful to avoid the tablet 
holder when moving the bike. Do not use the tablet holder as a handle 
to move the bike.  Make sure to adjust the leveling feet so that the bike 
remains stable at all times.