SPINNER® ASCENT
OWNER’S MANUAL
www.spinning.com 800-847-SPIN (7746)
7
WARNING!
save
these
instructions
THE FLYWHEEL MOMENTUM OF THE BIKE WILL KEEP THE PEDALS TURNING EVEN
AFTER THE USER STOPS PEDALING OR IN THE EVENT THE USER’S FEET SLIP OFF
THE PEDALS. DO NOT DISMOUNT THE BIKE OR ATTEMPT TO REMOVE YOUR FEET
FROM THE PEDALS UNTIL BOTH THE PEDALS AND THE FLYWHEEL HAVE STOPPED
COMPLETELY. FAILURE TO COMPLY MAY LEAD TO LOSS OF CONTROL AND SERIOUS
PERSONAL INJURY.
STEP 4:
INSTALL THE HANDLEBARS
Unscrew, pull out and hold the handlebar
pop-pin. Slide the handlebar post all the
way into the handlebar tube. Release the
handlebar pop-pin. Adjust the handlebars to
make sure pop-pin is engaged. Tighten the
handlebar pop-pin securely.
STEP 5:
INSTALL THE PEDALS
Turn the resistance knob all the way to
the right until crank arms are immobilized.
Remove pedal packaging.
note:
Pedals are always tightened by turning the
spindle toward the front of the bike. Be sure to
install the pedals on the correct side of the bike.
The pedal spindles are marked “L” (LEFT) and
“R” (RIGHT) to aid in assembly. Left and right are
referenced from a seated position on the bike.
Install the LEFT PEDAL on the LEFT CRANK.
Use the multi-wrench supplied and turn
counterclockwise
to tighten. Install the
RIGHT PEDAL on the RIGHT CRANK. Use the
multi-wrench supplied and turn
clockwise
to
tighten.
Be sure both pedals are tightened securely.
STEP 6:
LEVEL THE BIKE
Move the bike to the location where it will be
used. Your Spinner® Ascent requires
1.2 m x 1.8 m (4 x 6 ft.) of floor space for proper
operation. Rock the bike gently to check for
wobble. If needed, use the leveling adjusters
under the front and rear stabilizer bars to
steady the bike.
4
5
6
Summary of Contents for Spinner Ascent
Page 1: ...OWNER S MANUAL...
