8
Use this checklist to perform the bike test procedure.
» Recheck all the bolts, and make sure they are all tightened and that
no parts are missing.
» Test the handlebar and seat post to make sure they move freely and
you are able to lock them at different positions.
» Check the seat to make sure it is level and tight, and does not rotate
around or tilt. Tighten and adjust as needed.
» Test the seat slider for movement front to rear and check it by setting
it at different settings.
» Brake tension is adjustable using the red resistance knob in the front
of the bike. Pressing down on the knob will apply the brake if you
need to stop quickly.
» Adjust seat post and handlebar post to your needs.
Refer to
Guide to Ride
or
www.spinning.com
.
» Pedal at a moderate pace and test for proper and smooth resistance
changes while varying the amount of turns on the resistance knob.
» To move the bike after testing is complete, stand in front the
bike, grasp the handlebars and tip the bike toward you until the
transportation wheels are touching the floor. Roll the bike to the
desired location and then gently lower the rear of the bike back to the
floor. Adjust the leveling feet so that the bike is stable.
testing the Bike
WARNING!
save
these
instructions
THE FLYWHEEL MOMENTUM OF THE BIKE WILL KEEP THE PEDALS TURNING EVEN
AFTER THE USER STOPS PEDALING OR IN THE EVENT THE USER’S FEET SLIP OFF
THE PEDALS. DO NOT DISMOUNT THE BIKE OR ATTEMPT TO REMOVE YOUR FEET
FROM THE PEDALS UNTIL BOTH THE PEDALS AND THE FLYWHEEL HAVE STOPPED
COMPLETELY. FAILURE TO COMPLY MAY LEAD TO LOSS OF CONTROL AND SERIOUS
PERSONAL INJURY.
