10
luBricating the chain
1)
Locate the flywheel adjustment cover on the front right side of
your Spinner Pace.
2)
Using a flat head screwdriver, gently pop out the flywheel
adjustment cover from the chain guard. This will expose a small
section of the chain.
3)
Use a chain lube such as SPINTECH® Silicone Fitness Lube or
other oil-based lubricant with a spray nozzle.
Do not
use a wax-
based lubricant.
4)
When spraying the lubricant onto the chain, cover the floor under the
bike and take care not to allow the lubricant to drip onto the floor.
5)
Lock the brake by turning the resistance knob clockwise. With
the brake locked up, spray the lube onto the chain. Loosen
the brake and rotate the chain carefully and slowly, by hand,
approximately a quarter turn. Then stop it, tighten the brake
again and spray lube onto the next portion of the chain. Repeat
the above steps a total of six times to lubricate the entire chain.
6)
Carefully replace the flywheel adjustment cover. Your Spinner
Pace is now ready for testing.
» SPINTECH® lubricants, polish and grease are available
at www.spinning.com.
During heavy use of your Spinner® Pace, it may become necessary
to lubricate your chain to reduce chain associated noises. If you
have any questions regarding lubricating your chain, please contact
customer service at
888-704-SPIN (7746)
for assistance.
2009.11.16-0013797. Copyright © 2011 Mad Dogg Athletics, Inc. All rights reserved. Spin®, Spinner®, Spinning®, the Spinning logo, Peak Pilates®,
Resist-A-Ball® and Bodyblade® are registered trademarks that are owned or used under exclusive license by Mad Dogg Athletics, Inc.
