» spinner® pace owner’s manual
11
chain tension & aDJustment
The chain on your bike has been factory set and lubricated. It
should not require adjustment initially. Over time, however, you may
need to adjust the tension. If you have any questions regarding your
chain tension, please contact customer service at
888-704-SPIN
(7746)
for consultation prior to adjusting the tension of the chain.
1)
To access the axle nut on the right side of the
Spinner Pace you will need to first remove
the flywheel adjustment cover. Using a flat
head screw driver gently pop out the flywheel
adjustment cover from the chain guard. (see
photos on page 10)
2)
Using the multi-wrench, loosen the axle nuts
on the right (fig. 1) and left (fig. 2) sides of the
flywheel. Using the multi-wrench, loosen the
adjustment lock nuts on both sides of the
flywheel.
3)
To tighten the chain, turn the adjustment
screw in a clockwise rotation equally on both
sides using a multi-wrench (fig. 3 on
next page).
2
1
WARNING!
save
these
instructions
REMOVAL OF THE CHAIN GUARD IS STRONGLY DISCOURAGED AND SHOULD ONLY
BE PERFORMED BY AN AUTHORIZED TECHNICIAN. FAILURE TO FOLLOW THESE
INSTRUCTIONS MAY RESULT IN SEVERE INJURY.
ri
GHT
le
FT
FRONT
BACK
noTe:
If the flywheel adjustment cover does not allow enough space to
access the adjustment screw, you will need to remove the front chain guard.
