» spinner® pace owner’s manual
7
WARNING!
save
these
instructions
THE FLYWHEEL MOMENTUM OF THE BIKE WILL KEEP THE PEDALS TURNING EVEN
AFTER THE USER STOPS PEDALING OR IN THE EVENT THE USER’S FEET SLIP OFF
THE PEDALS. DO NOT DISMOUNT THE BIKE OR ATTEMPT TO REMOVE YOUR FEET
FROM THE PEDALS UNTIL BOTH THE PEDALS AND THE FLYWHEEL HAVE STOPPED
COMPLETELY. FAILURE TO COMPLY MAY LEAD TO LOSS OF CONTROL AND SERIOUS
PERSONAL INJURY.
4
4)
INstALL tHE HANdLEBARs
Unscrew, pull out and hold the handlebar pop-
pin. Slide the handlebar post all the way into
the handlebar tube. Release the handlebar
pop-pin. Adjust the handlebars to make sure
pop-pin is engaged. Tighten the handlebar
pop-pin securely.
5)
INstALL tHE PEdALs
Turn the resistance knob all the way to
the right until crank arms are immobilized.
Remove pedal packaging.
note:
Pedals are always tightened by turning the
spindle toward the front of the bike. Be sure to
install the pedals on the correct side of the bike.
The pedal spindles are marked “L” (LEFT) and
“R” (RIGHT) to aid in assembly. Left and right are
referenced from a seated position on the bike.
Install the LEFT PEDAL on the LEFT CRANK.
Use the multi-wrench supplied and turn
counterclockwise
to tighten. Install the
RIGHT PEDAL on the RIGHT CRANK. Use the
multi-wrench supplied and turn
clockwise
to tighten. Remember, pedals are always
tightened by turning the spindle toward the
front of the bike.
Be sure both pedals are tightened securely.
6) LEVEL tHE BIKE
Move the bike to the location where it will be
used. Your Spinner® Pace requires 4’ x 6’ of
floor space for proper operation. Rock the bike
gently to check for wobble. If needed, use
the leveling adjusters under the front and rear
stabilizer bars to steady the bike.
6
5
