3 - Setting Up Your Machine
3.5 - Adding the Oil
Page 07
Remove the back cover by unscrewing the eight (8) hex screws that hold it in place.
Remove the Cap on the Oil Tank.
Insert the Plastic Funnel, included with the machine, into the Oil Tank and, using the new batch of Hydrol HL Oil
(HL3HY) included with the machine, fill the tank with 1-1/2 gallons or until the Oil Tank is approximately 3/4 filled with
oil.
Replace the Cap making sure it is sealed securly.
Replace the Back Cover by securing the eight (8) hex screws that hold it in place.
After adding the oil it will be necessary to work the air out of the system. This is done by turning the power to the
Hydraulic Motor on and activating the foot pedal to raise and lower the table. Air in the hydraulic lines may make the
table motion irratic. Continue raising and lowering the table until the machine responds in the usual way indicating
the all the air has been bled out of the hydraulic lines.
Diagram 3-25
3.5.1
3.5.2
3.5.3
3.5.4
3.5.5
3.5.6
Oil Tank
Hydrol HL (included)
Funnel (included)
Summary of Contents for FMMH 3.1
Page 4: ...2 Safety 2 2 Warning Labels Page 03 WARNING DO NOT EXPOSE TO RAIN OR USE IN DAMP LOCATIONS...
Page 20: ...7 Parts Diagrams 7 1 Side View Page 19...
Page 21: ...7 Parts Diagrams 7 2 Head Assembly Page 20...
Page 22: ...7 Parts Diagrams 7 3 Spindle and Chuck Assembly Page 21...
