3 - Setting Up Your Machine
3.6 - Attaching the Paper Side Stops
Page 08
3.6.1
Diagram 3-30
Attach the Paper Side Stops (FM4-4006) using two (2) Side Stop
Screws (FM4-4007) each. Position the Paper Side Stop as de-
sired and tighten down with light pressure.
3.7 - Attaching the Chip Bag
3.7.1
Diagram 3-50
Attach the Chip Bag (FMM6-652A) to the machine by stretching
the mouth of the bag over the Master Chip Chute and hooking
the aluminum bar onto the bracket located on the top flat portion
of the master chip chute as shown. Please note that you must
empty this bag as needed to avoid clogging.
Master Chip Chute
Chip Bag
Table
Paper Side Stop
Side Stop Screws
3.8 - Electrical Instructions
3.8.1
3.8.2
Your FMMH-3.1 comes with an electrical cord containing the plug
to fit into standard grounded 115V outlets. This machine has a
combined full load draw of 18.8 Amps and requires a 20 Amp
Circuit.
Making sure that nothing is interfering with the drill bits, plug the
cord set into a grounded 115V outlet. To turn the Drill Motor on,
face the machine and press the Rocker Switch on the left-hand
side labeled “Drill Motor.” To turn the Table Motor on, face the ma-
chine and press the Rocker Switch on the right-hand side labeled
“Table Motor.”
Diagram 3-60
Rocker Switch
(Drill Motor)
Rocker Switch
(Table Motor)
Summary of Contents for FMMH 3.1
Page 4: ...2 Safety 2 2 Warning Labels Page 03 WARNING DO NOT EXPOSE TO RAIN OR USE IN DAMP LOCATIONS...
Page 20: ...7 Parts Diagrams 7 1 Side View Page 19...
Page 21: ...7 Parts Diagrams 7 2 Head Assembly Page 20...
Page 22: ...7 Parts Diagrams 7 3 Spindle and Chuck Assembly Page 21...
