3.696.5275.210
13
Product Features and Specifications
CSM-C family of Steam Generators, employing the U-Bend heat exchanger coil(s),
are the most economical method of furnishing clean steam when steam is used as the
energy source. All Spirax Sarco Compact Steam Generators are Packaged and ready
for installation. All components are sized, mounted, piped, and tested prior to shipment.
Each unit is built to exact design specifications and requires only connection to energy,
water, power, safety discharge, blowdown discharge line and / or pneumatic sources to
be ready for operation. The packaging concept provides a compact size that is ideal for
new installations, or for use as replacement of existing steam generators. The compact
size requires less space for installation. Each unit employs a Stainless Steel feed water
heating tank and generator body. All components used in the unit are of highest quality
and meet all design requirements. Each Compact Steam Generator is accompanied by
this Installation, Operation, and Maintenance Manual, as well as all documentation of
each major component. If any of these documents are missing, contact either Spirax
Sarco or your authorized sales representative before attempting installation, operation,
or maintenance procedures.
Installation Transporting and Unpacking the Unit
CSM-C Compact Steam Generators are usually shipped uncrated, the units can be lifted
by means of a forklist truck, placing the forks on the underside of the frame structure, in a
central position thus evenly distributing the units weight and providing a stable, balanced
load, refer to Fig. 3.
∆
If crated when shipped, the unit should only be lifted at the areas indicated
on the crate. Improper lifting of the unit may result in damage to the unit.
Location Requirements
CSM-C Compact Steam Generators are designed for indoor use only, unless otherwise
required by the design specifications. The unit should be located on a level surface (no
more than one-half degree [½°] of slope), capable of supporting the total weight of the unit
when filled to capacity. If crated when shipped, the crating should be carefully removed.
The unit can then be manoeuvered into place using the mounted wheels, safely installed
and then secured using the four footmounts.
Examining the Unit
After the unit has been set in place, it should be carefully examined to assure that neither the
main unit nor any of the components have been damaged during shipping. If any evidence
of damage is detected, contact Spirax Sarco or your authorized sales representative, to
report the damage and to receive instructions on how to proceed. After the unit and all
components have been inspected for damage. It is suggested that all pressure and control
components be checked to assure that they are to design specifications. This can be
done by reviewing the design specifications (included with the unit) and the specification
tags / plates attached to each component. Contact Spirax Sarco or your authorized sales
representative, before proceeding with the installation.
Fig. 3
Example
Summary of Contents for CSM-C
Page 6: ...3 696 5275 210 2...
