DC5V
From AC Power Adaptor
Plug the Power Cable into the
DC 5V
port.
Note: Ensure the USB flash drive is inserted before powering up the
device, and your smartphone is ready to receive the BLUETOOTH
confirmation messages.
Also
If using an Ethernet cable make sure it is plugged in before adding
power.
1.
LOCATE ALL REQUIRED CABLES
You should have;
1 x Ethernet cable
1 x AC Power Adaptor
2.
MOUNT UNIT TO THE WALL
Use
the (optional) mounting
bracket supplied.
3.
ATTACH ANTENNA
Screw in until finger-tight.
4.
CONNECT ETHERNET CABLE
Connect the Ethernet cable
from the
unit to a DHCP-enabled
network
which allows public internet
access.
NOTE: Not providing Ethernet
connectivity will result in limited fault
isolation in the event of a network or
probe failure
5.
INSERT USB FLASH DRIVE
This contains the CONFIG File used
to
boot-up the probe.
6.
CONNECT POWER CABLE
Spirent TestCenter Live
4150 Installation Guide
(USB flash drive not included)
