9
STEP 4
1.
Gather
HARDWARE FOR STEP 4.
2.
Remove the foam from the console mast axles and the plastic ties from the swing arm
tube.
3.
The swing arms will be labeled “L” for left and “R” for right. Slide the LEFT SWING ARM (5)
onto the left console mast axle. The swing arms have been preassembled at the factory to
assure a proper fit. The fit will be snug. Please do not force the arm on the axle or use a
hammer, as damage to the bearings could occur.
4.
Secure the swing arm to the mast with the BUSHING WASHER (51) and the SOCKET
HEAD CAP BOLT (89). Tighten with the 8mm L WRENCH.
5.
Snap on the decorative BUSHING ROUND END CAP (79).
6.
Repeat these steps on the right side.
HARDWARE
#51.
M10
Bushing Washer
(2 pcs)
#89.
M10 × 20m/m
Socket Head Cap Bolt
(2 pcs)
Summary of Contents for 161173795US
Page 32: ...32 Exploded View Diagram...
