Page 46 of 54
How to Find the Hand Set
If you have misplaced the handset you can page it by pressing the + button
only on the fire control for around 5 seconds. The handset will flash and make a
noise to help you to locate it. Once you pick up the TESC it knows you hold it
and so the sound stops. The flashing and sound will last for 60 seconds each
time the handset is paged as described. If not found in 60 seconds, page again
and so on.
NOTE: PRESS “+” Button ONLY , NOT “+” and “-‘ Together as you will
accidentally break the handset pairing and have to reset handset to
factory state and pair again (see other parts of the booklet if this
happens).
Pairing the Handset.
WARNING:
There should be no reason to do this with a new or working fire as
the pairing has been done at the factory. This is only to be used in the event of
fitting a new control box or using a new handset. Using these instructions on a
new fire will erase all of the factory settings. If you are experiencing difficulty
using the handset on a new fire we suggest reading the above instructions again
or using the YouTube videos.
DO NOT USE THESE INSTRUCTIONS ON A NEW FIRE OR WORKING FIRE
If either the handset is reset or the gas control has the pairing operation
buttons operated, the current pairing will be broken and both the two operations
below will be required to be done to enable a new pairing to be set up. This will
need a gas engineer to enter the gas controls inside the fire.
