Customer Service 1-888-707-1880
Dyaco Canada Inc. 2016
Email: customerservice@dyaco.ca
38
BELT/DECK
LUBRICATION PROCEDURE
Do not lubricate with other than approved lubricant. Your treadmill
comes with one tube of lubricant and extra tubes can be ordered
directly from your authorized dealer. There are commercially available
lube kits, but the only one currently approved is Lube-N-Walk.
Keeping the deck lubricated at the recommended intervals ensures the
longest life possible for your treadmill. If the lubricant dries out, the friction between the belt and
deck rises and places undue stress on the drive motor, drive belt and electronic motor control board,
which could result in catastrophic failure of these expensive components. Failure to lubricate the
deck at regular intervals may void the warranty. The belt & deck come pre-lubricated and
subsequent lubrication should be performed every 90 hours of use. The console has a built in
lubrication reminder indicator that lights every 90 hours of use.
Use the Lubricant to lubricate the deck beneath the belt. If you can reach under the belt approximately
6” on each side, use the following procedure: Unplug the electrical cord. At the middle of the deck, lift
up on the belt and reach under with the tube of lubricant. Squirt most of the lubricant on the deck
surface. Repeat the process on the opposite side. Plug the electrical cord back into the outlet and walk
on the belt at a moderate speed for five minutes.
If unable to perform the above procedure, it will be necessary to loosen the walking belt. Using the 6
mm Allen wrench supplied, loosen the two rear roller adjustment bolts -- located in the rear end
caps
– enough to get your hand under the belt (5 –10 turns). Make sure to loosen both bolts the
same amount of turns and also remember how many turns, because when finished you will need to
tighten the bolts back to the point they were before.
Once the belt is loose, wipe the deck with a clean lint free cloth to remove any dirt. Apply the whole
tube of lubricant onto the deck surface about 45 cm (18 inches) from the motor cover. Squeeze out
the contents of the tube across the deck (parallel to the motor cover) in about a one-foot line, like
toothpaste on a toothbrush. The one-foot line should be in the middle of the deck at approximately
equal distance from both side edges of the belt. You want the lubricant to be applied about the spot
that your feet would hit the belt as you are walking. This should be about 18 inches from the motor
cover, but you may want to walk on the treadmill before loosening the belt to note where your feet
land on the belt. If you mostly use the treadmill for running, the spot where your feet land may be
different from walking. Once the lubricant is applied, tighten the rear roller bolts the same amount of
turns as when you loosened them. Run the treadmill at about 5 KPH (3 MPH) without walking on it
for about a minute or two to make sure the belt stays in the middle of the deck. If the belt tracks to
one side then follow the belt tracking instructions to remedy. Now the deck is lubricated and you
should walk, not run, on the treadmill immediately for at least 5 minutes to ensure the lubricant is
evenly distributed. If you purchase a silicone based Lube-N-Walk kit, follow the instructions that
come with it to apply the lubrication.
