Customer Service 1-888-707-1880
Dyaco Canada Inc. 2021
Email: customerservice@dyaco.ca
51
CALIBRATION PROCEDURE
1. Remove the safety key.
2. Press and hold down the Start and Speed Up buttons and replace the safety button. Continue to
hold the Start and
Speed Up button until the window displays "Factory settings", then press the Enter button.
3. You will now be able to set the display to show Metric or Imperial settings (Meters vs. Miles). To
do this, press the Up or Down button to show which you want, then press Enter.
4. Make sure the wheel size diameter is 2.98 then press Enter.
5. Adjust the minimum speed (if needed) to 0.5 and then press Enter.
6. Adjust the maximum speed (if needed) to 12.0 and then press Enter.
7. Adjust the maximum elevation (if needed) to 15 and then press Enter.
8. Press Start to begin calibration. The process is automatic; the speed will start up without warning,
so do not stand on the belt.
ADJUSTING THE SPEED SENSOR
If the calibration does not pass you may need to check the speed sensor alignment.
1. Remove the motor cover hood by loosening the 10 screws that hold it in
place. Set it aside.
2. The speed sensor is located on the left side of the frame, right next to the
front roller pulley (the pulley will have a belt around it that also goes to the
motor). The speed sensor is a small rectangular shaped black box with a
wire connected to it.
3. You will see a magnet on the outside edge of the pulley; make sure the
speed sensor is aligned with the center of the magnet when it passes by.
There are two screws that hold the sensor in place that need to be
loosened to adjust the sensor. Re-tighten the screws when finished.
GENERAL MAINTENANCE
1. After each workout, wipe down all areas exposed to sweat with a damp cloth.
2. Ensure all bolts are properly tightened after assembly and before each use.
3. Ensure that the unit is properly levelled after assembly and before each use. Use levelling pads
on the bottom of the feet to adjust height.
